Go into Input Settings, choose XInput as a source and assign buttons normally.If using Joycons, CemuHook will detect two controllers - each will give all buttons, but choosing one over the other just chooses preference for which hand to use for gyro controls.Start Cemu and ensure CemuHook has the controller selected.Run as Administrator if your keyboard/mouse button mappings don't work.Run Drivers/ViGEmBus_Setup_1.16.116.exe.Read the READMEs (they're there for a reason!).

I think this project was responsible for both software jobs I landed so far, so I am quite proud of it.

It's been quite a wild ride, with nearly 590k (!!) official download on GitHub and probably many more through the nightlies. Thank you for your patience in that regard too! I don't have too much time to work on this project, but I will try to fix bugs when and if they arise. I started writing this project a while back and have since then learnt a lot more about programming and software development in general. Thank you for using my software and all the constructive feedback I've been getting about it. If anyone would like to donate (for whatever reason), you can do so here.

It also allows using the gyro to control your mouse and remap the special buttons (SL, SR, Capture) to key bindings of your choice. Allows the Nintendo Switch Pro Controller, Joycons, and Switch SNES controller to be used with Cemu using Cemuhook, Citra, Dolphin, Yuzu, and system-wide with generic XInput support.

Software lag switch safe